Table of Contents
Advertisement
In this chapter, we will describe how you commission the CANsync-Master for b maXX
PLC option module that you just assembled and installed (see
–
from page 21 onward). Commissioning ensures that the CANsync-Master option mod-
ule functions correctly. For more information on programming refer to the "b maXX PLC
Application Manual" and the "CANsync-Master Option Module for b maXX Application
Manual".
Before starting commissioning, ensure that the following conditions have been met:
1 The plug-in module has been assembled correctly.
2 The plug-in module has been installed correctly.
3 All the safety equipment has been commissioned.
4 The b maXX unit is ready for use.
6.1
General safety regulations
h Observe the
GEFAHR (DANGER)
Folgendes wird eintreffen, wenn Sie diesen Warnhinweis nicht beachten:
m schwere Körperverletzung
Danger from: mechanical effects. At commissioning, the drive can rotate.
Keep far enough the rotating parts. Note that when drives are starting up machine parts can
be set in motion. In all cases, activate the machine's safety devices.
6.2
Requirements of the personnel carrying out work
Commissioning work must only be carried out by trained specialists who have understood
the safety regulations and information and can implement them.
Operating Instructions CANsync-Master Option Module for BM4-O-PLC
ZBasic Safety Instructions –
m Tod
C
OMMISSIONING
6
ZAssembly and installation
from page 7 onward.
BM4-O-CAN-06
29
von 56
Advertisement
Table of Contents
