Table of Contents
Advertisement
MAINTENANCE
!
WARNING
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional/professional codes and
regulations.
Prior to any maintenance concerning
electrical components of this
equipment, ensure electrical supply
to the equipment is disconnected.
Label all wires prior to disconnection;
wiring errors may cause improper
and hazardous operation.
Follow all proper lockout/tagout
procedures for service.
Before beginning any maintenance,
ensure area is free of any combustible
materials and other dangers.
What to do if you smell gas:
Do not try to light the appliance.
Do not touch any electrical switch.
Do not use any phone in the building.
Leave building and contact gas
supplier from neighbor's phone. If you
cannot reach gas supplier, phone the
fire department.
After initial start-up by qualified
personnel, linkage, control settings,
and fuel pressures should not be
readjusted.
4
CAUTION
All maintenance procedures should
be completed by trained personnel.
Appropriate training and instructions
are available from the Fulton Service
Department at (315) 298-5121 or
your local Fulton Heating Solutions
Representative.
In order to meet warranty conditions,
ensure all appropriate maintenance
activities are performed.
4-2
General
Your Endura+ boiler has been designed to provide years of trouble free
performance. To ensure continued safety and efficiency of the boiler, please follow
the maintenance and inspection directions outlined in this section of the manual.
Daily, Weekly and Monthly Maintenance and Inspection are considered good
practice for any boiler, and is applicable to the full line of Endura+ boilers. It is
also good practice for any boiler installation to perform a thorough review of
the overall system on a regular basis, and after any maintenance procedures.
Any potential issues should be noted and followed up on to ensure safety and
reliability of all relevant equipment. System review items may include:
Looking for discoloration of any painted equipment, boiler jacket panels,
ƒ
and/or insulation used in system piping.
Carefully checking for gas leaks using a combustible gas detector during
ƒ
commissioning and regular inspactions; a Gasmate® 0119 or equivalent is
recommended. This includes, but is not limited to, gas delivery system, gas
train fittings, pressure switches, gas valves, regulators, conduit connections
to gas devices, and pre-mix delivery components.
Looking for evidence of leaks including the air intake/exhaust systems,
ƒ
boilers, hydronic system piping, pumps, valves and other system
components.
ƒ
Once boilers are running, making sure there are no flue gases around the
boilers, or in the boiler room.
OOEE:
Combustion analysis and adjustment schedule can vary based on boiler
–
application and seasonal conditions. Biannual or quarterly adjustment may be
optimal in some applications—for example, systems operating as both winter
heat and summer reheat.
Daily Maintenance and Inspection Schedule
Daily maintenance and inspection must include the following:
1. Observe operating temperature and general conditions.
2. Verify that the flow of combustion and ventilating air to the boiler is not
obstructed.
3. Boiler area is free and clear of any combustible materials, including
flammable vapors and liquids.
Weekly Maintenance and Inspection Schedule
Weekly maintenance and inspection must include the following:
1. Observe the conditions of the main flame. Correct fuel/air adjustment
is essential for the efficient and reliable operation of this boiler. If an
adjustment to the combustion is necessary, the flue gas composition
should be checked with a carbon dioxide (CO2) or oxygen (O2) analyzer to
set conditions.
SECTION 4
EDRP-IOM-2019-0212
© Fulton Group N.A., Inc. 2019
Hide quick links:
Advertisement
Table of Contents
