Cisco Catalyst 2960-XR Security Configuration Manual page 310
Ios release 15.0 2 ex1
Hide thumbs
Also See for Catalyst 2960-XR:
- Configuration manual (196 pages) ,
- Configuration manuals (120 pages) ,
- Reference (52 pages)
Table of Contents
Advertisement
Configuring a Supplicant Switch with NEAT
Command or Action
encapsulation dot1q
Step 9
switchport mode trunk
Example:
Switch(config-if)# switchport mode trunk
Step 10
dot1x pae supplicant
Example:
Switch(config-if)# dot1x pae supplicant
Step 11
dot1x credentials profile-name
Example:
Switch(config-if)# dot1x credentials test
Step 12
end
Example:
Switch(config-if)# end
Step 13
show running-config interface interface-id
Example:
Switch# show running-config interface
gigabitethernet1/0/1
Step 14
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 15
Configuring NEAT with Auto Smartports Macros
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
288
Configuring IEEE 802.1x Port-Based Authentication
Purpose
Configures the interface as a VLAN trunk port.
Configures the interface as a port access entity (PAE)
supplicant.
Attaches the 802.1x credentials profile to the interface.
Returns to privileged EXEC mode.
Verifies your configuration.
(Optional) Saves your entries in the configuration file.
You can also use an Auto Smartports user-defined macro
instead of the switch VSA to configure the authenticator
switch. For more information, see the Auto Smartports
Configuration Guide for this release.
OL-29434-01
Advertisement
Table of Contents
