Cisco Catalyst 2960-XR Security Configuration Manual page 287
Ios release 15.0 2 ex1
Hide thumbs
Also See for Catalyst 2960-XR:
- Configuration manual (196 pages) ,
- Configuration manuals (120 pages) ,
- Reference (52 pages)
Table of Contents
Advertisement
Configuring IEEE 802.1x Port-Based Authentication
Beginning in privileged EXEC mode, follow these steps to globally enable MAC move on the switch. This
procedure is optional.
SUMMARY STEPS
1. configure terminal
2. authentication mac-move permit
3. end
4. show running-config
5. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2
authentication mac-move permit
Example:
Switch(config)# authentication mac-move
permit
Step 3
end
Example:
Switch(config)# end
Step 4
show running-config
Example:
Switch# show running-config
Step 5
copy running-config startup-config
Example:
Switch# copy running-config startup-config
OL-29434-01
Purpose
Enters global configuration mode.
Enables MAC move on the switch. Default is deny.
In Session Aware Networking mode, the default CLI is
access-session mac-move deny. To enable Mac Move in
Session Aware Networking, use the no access-session
mac-move global configuration command.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
Enabling MAC Move
265
Advertisement
Table of Contents
