Stacking Guidelines For Session Termination; Stacking Guidelines For Coa-Request Bounce-Port; Stacking Guidelines For Coa-Request Disable-Port - Cisco Catalyst 2960-XR Security Configuration Manual

Configuring RADIUS
If the switch fails before returning a CoA-ACK to the client, the process is repeated on the new active switch
when the request is re-sent from the client. If the switch fails after returning a CoA-ACK message to the client
but before the operation has completed, the operation is re-started on the new active switch.
Related Topics
Session Identification, on page 57

Stacking Guidelines for Session Termination

No special handling is required for CoA Disconnect-Request messages in a switch stack.

Stacking Guidelines for CoA-Request Bounce-Port

Because the bounce-port command is targeted at a session, not a port, if the session is not found, the command
cannot be executed.
When the Auth Manager command handler on the stack master receives a valid bounce-port command, it
checkpoints the following information before returning a CoA-ACK message:
• the need for a port-bounce
• the port-id (found in the local session context)
The switch initiates a port-bounce (disables the port for 10 seconds, then re-enables it).
If the port-bounce is successful, the signal that triggered the port-bounce is removed from the standby stack
master.
If the stack master fails before the port-bounce completes, a port-bounce is initiated after stack master
change-over based on the original command (which is subsequently removed).
If the stack master fails before sending a CoA-ACK message, the new stack master treats the re-sent command
as a new command.

Stacking Guidelines for CoA-Request Disable-Port

Because the disable-port command is targeted at a session, not a port, if the session is not found, the command
cannot be executed.
When the Auth Manager command handler on the stack master receives a valid disable-port command, it
verifies this information before returning a CoA-ACK message:
• the need for a port-disable
• the port-id (found in the local session context)
The switch attempts to disable the port.
If the port-disable operation is successful, the signal that triggered the port-disable is removed from the standby
stack master.
If the stack master fails before the port-disable operation completes, the port is disabled after stack master
change-over based on the original command (which is subsequently removed).
If the stack master fails before sending a CoA-ACK message, the new stack master treats the re-sent command
as a new command.
OL-29434-01
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
RADIUS Change of Authorization
61