Cisco Catalyst 2960-XR Security Configuration Manual page 318

Configuring Open1x
SUMMARY STEPS
1. configure terminal
2. interface interface-id
3. switchport mode access
4. authentication control-direction {both | in}
5. authentication fallback name
6. authentication host-mode [multi-auth | multi-domain | multi-host | single-host]
7. authentication open
8. authentication order [ dot1x | mab ] | {webauth}
9. authentication periodic
10. authentication port-control {auto | force-authorized | force-un authorized}
11. end
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
Switch# configure terminal
Step 2
interface interface-id
Example:
Switch(config)# interface gigabitethernet 1/0/1
Step 3
switchport mode access
Example:
Switch(config-if)# switchport mode access
Step 4 authentication control-direction {both | in}
Example:
Switch(config-if)# authentication control-direction
both
Step 5 authentication fallback name
Example:
Switch(config-if)# authentication fallback profile1
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
296
Configuring IEEE 802.1x Port-Based Authentication
Purpose
Enters the global configuration mode.
Specifies the port to be configured, and enter interface
configuration mode.
Sets the port to access mode only if you configured
the RADIUS server.
(Optional) Configures the port control as
unidirectional or bidirectional.
(Optional) Configures a port to use web authentication
as a fallback method for clients that do not support
802.1x authentication.
OL-29434-01