Local Override Channel Mapping; Txm1.8P; Channel Process Data Channel Mapping - Siemens TX-I/O User Manual

AO – analog output-
configured channels
BO-, AO-, MO-
configured channels
Designation
Supported functions
AI – analog input-
configured channels
Siemens
Building Technologies
AO channel Offset to output
address
Channel 1 Subslot 2 Byte 1
Channel 2 Subslot 3 Byte 1
Channel 3 Subslot 4 Byte 1
Channel 4 Subslot 5 Byte 1
Channel 5 Subslot 6 Byte 1
Channel 6 Subslot 7 Byte 1
Channel 7 Subslot 8 Byte 1
Channel 8 Subslot 9 Byte 1
7.5.2

Local Override Channel Mapping

BO, AO, MO channel Offset to input
address
Channel 1 Subslot 1 Byte 0
Channel 2 Subslot 1 Byte 0
Channel 3 Subslot 1 Byte 0
Channel 4 Subslot 1 Byte 0
Channel 5 Subslot 1 Byte 0
Channel 6 Subslot 1 Byte 0
Channel 7 Subslot 1 Byte 0
Channel 8 Subslot 1 Byte 0
7.6

TXM1.8P

TXM8P : PT100 module
AI_NI1K AI_PT1K375
AI_PT100_4_Climatic AI_R250
AI_PT100_4_Climatic AI_R2K5
7.6.1

Channel Process Data Channel Mapping

The table below shows the AI-configured channels.
AI channel Offset to input
address
Channel 1 Subslot 2 Byte 1
Channel 2 Subslot 3 Byte 1
Channel 3 Subslot 4 Byte 1
Channel 4 Subslot 5 Byte 1
Channel 5 Subslot 6 Byte 1
Channel 6 Subslot 7 Byte 1
Channel 7 Subslot 8 Byte 1
Channel 8 Subslot 9 Byte 1
TX-I/O PROFINET BIM V1.0
Module Data
Byte 0
Byte 0
Byte 0
Byte 0
Byte 0
Byte 0
Byte 0
Byte 0
Bit 0
Bit 1
Bit 2
The last bit (bit 0–7) in each case is responsible
Bit 3
for the mode (active/inactive) of the local override
function. For details, refer to the appropriate local
Bit 4
override mode parts in Section 4 – Parameters.
Bit 5
Bit 6
Bit 7
Byte 0
Byte 0
Byte 0
Byte 0
Byte 0
Byte 0
Byte 0
Byte 0
81 / 94
CM110564en_02
23.09.2010