Siemens TX-I/O User Manual page 16

Add a CPU
Add Profinet I/O system
Note
Add Profinet interface
later
16 / 94
Siemens
Building Technologies
1. Add a PLC CPU (e.g., CPU 317-2 PN/DP):
2. Hardware catalog: Open up the tree to the corresponding folder
3. Add the required version of the CPU to the rack by drag&drop.
During this action the corresponding field of the rack changes to
After dropping the CPU, the dialog field Ethernet interface properties opens.
1. Ethernet interface properties dialog field, Parameters tab:
a. Optional: Change the IP address and subnet mask
We recommend that the suggested address be left unchanged.
b. Subnetz group field: select the required subnet from the list box
If no subnet is displayed, continue with 2.
c. OK button.
2. Subnet group field: NEW button
Open the Properties dialog field – new subnet Industrial Ethernet
3. Properties dialog field – new subnet Industrial Ethernet, text field Name:
a. Enter the required subnet name
b. OK button.
The subnet name then appears in the selection of the Properties dialog
field – new subnet Industrial Ethernet.
4. Ethernet interface properties dialog field, Parameters tab:
a. Select subnet
b. OK button.
In the event of multiple selection options, an Ethernet interface must always be
selected.
The Profinet (Ethernet) interface can also be added at a later time. Proceed in this
case as follows:
1. Rightclick PNIO subslot
2. List field: Add Profinet I/O system
If the I/O system was already created, it is now automatically attached to
the subsystem.
Note
If the I/O system is not already available, please proceed as described above (Add
Profinet I/O system).
TX-I/O PROFINET BIM V1.0
Engineering
green.
CM110564en_02
23.09.2010