Diagnostics On Profinet Bim; Diagnostics In Telnet; Telnet Commands - Siemens TX-I/O User Manual

64 / 94
Siemens
Building Technologies
5.2

Diagnostics on Profinet BIM

LED indication
on off
on flashing
on on
flashing flashing
flashing off
flashing on
off on
on
5.3

Diagnostics in Telnet

5.3.1

Telnet Commands

The following commands are used on the DOS command level for working with
Telnet:
help firmware
Command Description
fwupdate Starts firmware update
cimiupdate Starts CIMI firmware update
cfgget Get device configuration
cfgupdate Update device configuration
calibrate Starts CIMI calibration
devicestop Stops Profinet IO Device
devicestart Starts Profinet IO Device
setPvMode Sets ComMode of a device
to Master/Slave or Frontend/Backend
help info
Command Description
devicelist Shows the device and module list
alarmlist Shows the active alarms
diagbasic Display the diagnostic and process
alarms
diagextended Display the extended diagnosis
ethstats Display the ethernet statistics
showlog Display trace log
version Display the firmware version
TX-I/O PROFINET BIM V1.0
Diagnostics
on
flickerin
g
flickerin
g
Description
Cause
Firmware runs without faults
Alarm present
Firmware is running, no Profinet
communication
Hardware problem
Firmware update is running, firmware is
running
Firmware update is running, firmware is
not running
Firmware is not running
Connection to Ethernet port 1 available
Connection to Ethernet port 2 available
Ethernet communication on port 1
Ethernet communication on port 2
CM110564en_02
23.09.2010