Removing The Fp-1600 And Terminal Bases From The Panel; Mount I/O Modules Onto Terminal Bases - National Instruments FieldPoint FP-1600 User Manual

Mount I/O Modules onto Terminal Bases

© National Instruments Corporation
3. Bolt, screw, or otherwise fasten the terminal base to the panel. Make
sure that the local bus connectors remain firmly mated after the
terminal base is mounted.
4. To add more terminal bases, repeat steps 1 through 3, mating the local
bus connectors of each new terminal base to the connector of the last
installed base. If all the pilot holes were correctly drilled, the local bus
connectors should remain firmly mated after all the bases are mounted
to the panel.
5. Place the protective cover onto the local bus connector of the last
terminal base on the bank.
Removing the FP-1600 and Terminal Bases from
the Panel
To remove an FP-1600 network module and terminal bases from the panel,
reverse the process described in the previous sections,
FP-1600 to a Panel and
First remove the terminal bases, starting with the last one, then remove the
FP-1600 network module.
Refer to Figure 2-5 and follow these steps to connect an I/O module to a
terminal base:
1. Make sure the ejector button on the terminal base is pressed down in
the unlocked position.
2. Position the first module with its alignment slots aligned with the guide
rails on the terminal base.
Chapter 2
Connecting Terminal Bases with Panel
2-5
Hardware and Software Installation
Mounting the
Mounting.
FieldPoint FP-1600 User Manual