National Instruments FieldPoint FP-1600 User Manual page 66

module configuration after HotPnP
replacement (table), 4-5 to 4-6
during operation, 4-4
during power-up, 4-4
replacing I/O modules, 4-5
I
installation, 2-1 to 2-10. See also HotPnP (Hot
Plug and Play).
cabling, 2-7 to 2-8
Ethernet cable pinouts (figure), 2-8
Ethernet connections (table), 2-7
connecting FP-1600 to network,
2-6 to 2-7
mounting I/O modules onto terminal
bases, 2-5 to 2-6
mounting on DIN rail, 2-1 to 2-3
connecting terminal bases, 2-2 to 2-3
procedure, 2-1 to 2-2
removing FP-1600 and terminal
bases, 2-3
mounting to panel, 2-3 to 2-4
connecting terminal bases, 2-4 to 2-5
procedure, 2-3 to 2-4
removing FP-1600 and terminal
bases, 2-5
power connection, 2-8 to 2-9
calculating power for FieldPoint
bank, 2-9
power connector pinout (figure), 2-9
powering on the FP-1600, 2-10
serial number information (note), 2-1
software installation, 2-10
I/O modules
inserting new, 4-5
mounting onto terminal bases, 2-5 to 2-6
replacing, 4-5
IP addresses. See Ethernet network.
ipcfg utility, 3-8
© National Instruments Corporation
L
LabVIEW VIs
diagram for example application
(figure), 3-18
overview, 1-3
using with FP-1600, 3-16 to 3-18
LabWindows/CVI functions
overview, 1-3
using with FP-1600, 3-18
LED indicators
description, B-5 to B-6
location on FP-1600 (figure), B-5
STATUS LED flashes and corresponding
error conditions (table), B-6
LINK LED, B-6
local bus, high-speed, 4-1
Lookout software, 3-15 to 3-16
accessing data (figure), 3-16
using with FP-1600, 3-15
M
manual. See documentation.
100 Mbps LED, B-6
mounting I/O modules onto terminal bases,
2-5 to 2-6
mounting on DIN rail, 2-1 to 2-3
connecting terminal bases, 2-2 to 2-3
procedure, 2-1 to 2-2
removing FP-1600 and terminal
bases, 2-3
mounting to panel, 2-3 to 2-4
connecting terminal bases, 2-4 to 2-5
procedure, 2-3 to 2-4
removing FP-1600 and terminal
bases, 2-5
I-3
Index
FieldPoint FP-1600 User Manual