Table of Contents
Advertisement
Chapter 2
Hardware Installation and Configuration
Removing the FBUS-HSE/H1 LD
FBUS-HSE/H1 LD User Manual
1
1 Cover
2 Lip
Figure 2-2. Mounting the FBUS-HSE/H1 LD on a DIN Rail
3.
Slide the FBUS-HSE/H1 LD to the desired position along the DIN rail.
After the FBUS-HSE/H1 LD is in position, lock it to the DIN rail by
pushing the rail clip to the locked position, as shown in Figure 2-1.
To remove a linking device, unlock it from the DIN rail by placing a
screwdriver in the slot on the rail snap and open the rail snap to the
unlocked position, as shown in Figure 2-1. Then lift the device off of the
rail.
4
3 35 mm DIN Rail
4 Press on to Rail
2-2
2
3
ni.com
Advertisement
Table of Contents
