Connecting Terminal Bases With Din Rail Mounting; Figure 2-2. Mounting The Fp-1600 Onto A Din Rail - National Instruments FieldPoint FP-1600 User Manual

Chapter 2 Hardware and Software Installation
Caution To avoid damaging the FP-1600 and the terminal bases, make sure that power
is not applied to the FP-1600 while you install or remove terminal bases.
FieldPoint FP-1600 User Manual
2. Hook the lip on the rear of the FP-1600 onto the top of a 35 mm
DIN rail and press the FP-1600 down onto the DIN rail, as shown
in Figure 2-2.
Cover

Figure 2-2. Mounting the FP-1600 onto a DIN Rail

3. Slide the FP-1600 to the desired position along the DIN rail. After the
FP-1600 is in position, lock it to the DIN rail by pushing the rail clip
to the locked position, as shown in Figure 2-1.
After the FP-1600 is mounted to the DIN rail, connect the terminal base to
the FP-1600 as explained in the next section,
with DIN Rail Mounting.

Connecting Terminal Bases with DIN Rail Mounting

Follow these steps to connect a terminal base to an FP-1600 network
module using DIN rail mounting.
Press
2-2
Local Bus
Connector
Lip
35 mm DIN Rail
Connecting Terminal Bases
www.natinst.com