Figure 3-4. Comm Resource Configuration Dialog Box - National Instruments FieldPoint FP-1600 User Manual

© National Instruments Corporation

Figure 3-4. Comm Resource Configuration Dialog Box

To use the FP-1600, change the Type from RS232/485 to Ethernet.
4.
Each Ethernet comm resource represents a single bank of FieldPoint
modules on the network.
5. If you already know the device's address, enter the address in the
Hostname or IP Address field, then proceed to the section
Configure Devices.
If you do not know the address, click on Browse to locate the device.
The Network Devices window appears, as shown in Figure 3-5.
Chapter 3
3-5
Hardware and Software Configuration
Find and
FieldPoint FP-1600 User Manual