National Instruments FieldPoint FP-1600 User Manual page 51

Note You should not need to select Reset Module unless you want to reset the device and
put it in storage.
© National Instruments Corporation
• Do not power off the module while the green PROCESS LED is on.
This LED indicates that the FP-1600 is updating its configuration or
receiving a firmware upgrade. If power is lost while the PROCESS
LED is on, the configuration settings could be lost.
• Use FieldPoint Explorer to reset the FP-1600 before moving it to a new
network or subnet. If you do not reset the FP-1600, the device might
be unable to communicate with the new network. To reset the FP-1600,
from the FP-1600 Properties window, click on Reset Module. This
resets the FP-1600 to the factory settings. When you click on this
button, the module returns to an unconfigured state. You must
reconfigure the module before you can use it again.
A-3
Appendix A Resetting the FP-1600
FieldPoint FP-1600 User Manual