Operation Manual – System Maintenance and Debugging
H3C S3610&S5510 Series Ethernet Switches
Press enter key when ready
Note:
If you have chosen 9600 bps as the download baud rate, you need not modify the
HyperTerminal's baud rate, and therefore you can skip Step 4 and 5 below and proceed
to Step 6 directly. In this case, the system will not display the above information.
Following are configurations on PC. Take the Hyperterminal using Windows operating
system as example.
Step 4: Choose [File/Properties] in HyperTerminal, click <Configure> in the pop-up
dialog box, and then select the baud rate of 115200 bps in the Console port
configuration dialog box that appears, as shown in Figure 3-1, Figure 3-2.
Figure 3-1 Properties dialog box
3-5
Chapter 3 Device Management