H3C S3610 Series Operation Manual page 35

Operation Manual – System Maintenance and Debugging
H3C S3610&S5510 Series Ethernet Switches
If you want to exit, Press <Ctrl+X>.
Loading ...CCCCCCCCCC
Step 7: Choose [Transfer/Send File] in the HyperTerminal's window, and click
<Browse> in pop-up dialog box, as shown in Figure 3-4. Select the software you need
to download, and set the protocol to XMODEM.
Figure 3-4 Send file dialog box
Step 8: Click <Send>. The system displays the page, as shown in Figure 3-5.
Figure 3-5 Sending file page
Step 9: After the download completes, the system displays the following information:
Loading ...CCCCCCCCCC done!
Step 10: Reset HyperTerminal's baud rate to 9600 bps (refer to Step 4 and 5). Then,
press any key as prompted. The system will display the following information when it
completes the loading.
Bootrom updating.....................................done!
3-7
Chapter 3 Device Management