H3C S3610 Series Operation Manual page 45

Operation Manual – System Maintenance and Debugging
H3C S3610&S5510 Series Ethernet Switches
Figure 3-13 Upload file switch.btm to the switch
Step 8: Configure switch.btm to be the BootROM at reboot, and then restart the switch.
<Sysname> bootrom update file switch.btm
This command will update bootrom file, Continue? [Y/N]y
Now updating bootrom, please wait...
BootRom file updating finished!.
<Sysname> reboot
When rebooting the switch, use the file switch.btm as BootROM to finish BootROM
loading.
Loading the host software is the same as loading the BootROM program, except for
that the file to be downloaded is the host software file, and that you need to use the
boot-loader command to select the host software at reboot of the switch.
Note:
The steps listed above are performed in the Windows operating system, if you use
other FTP client software, refer to the corresponding user's guide before operation.
Only the configurations steps concerning loading are illustrated here, for detailed
description on the corresponding configuration commands, refer to the chapter "File
System Management".
3-17
Chapter 3 Device Management