Device Management Configuration; Rebooting A Device; Specifying A Bootrom File For The Next Device Boot - H3C S3610 Series Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S3610&S5510 Series Ethernet Switches
II. Remote Loading Using TFTP
The remote loading using TFTP is similar to that using FTP. The only difference is that
TFTP is used instead off FTP to load software to the switch, and the switch can only act
as a TFTP client.

3.3 Device Management Configuration

3.3.1 Rebooting a Device

When a fault occurs to a running device, you can remove the fault by rebooting it,
depending on the actual situation. You can set a time at which the device can
automatically reboot. You can also set a delay so that the device can automatically
reboot in the delay.
Table 3-1 Follow these steps to reboot a device
Reboot the whole system
Enable the scheduled reboot
function and specify a specific
reboot time and date.
Enable the scheduled reboot
function and specify a reboot
wait time.
Display the reboot time of a
device.
Note:
The precision of the device timer is 1 minute. One minute before the reboot time, the
device will prompt "REBOOT IN ONE MINUTE" and will reboot in one minute.
You can use the reboot, schedule reboot at, and schedule reboot delay commands
to reboot a device. As a result, the ongoing services will be interrupted. You must be
careful to use these commands.

3.3.2 Specifying a BootROM File for the Next Device Boot

A BootROM file is an application file adopted by the device. When multiple BootROM
files are available on the storage media, you can specify an APP file for the next device
boot by executing the following command.
To do... Use the command...
reboot
schedule reboot at hh:mm
[ date ]
schedule reboot
{ hh:mm | mm }
display schedule reboot
3-18
Chapter 3 Device Management
Remarks
Optional
Optional
By default, the
scheduled
reboot function
delay
is disabled.
Optional
You can carry
out
command in any
view.
the