H3C S3610 Series Operation Manual page 36

Hide thumbs Also See for S3610 Series:

Table of Contents

Operation Manual – System Maintenance and Debugging

H3C S3610&S5510 Series Ethernet Switches

Note:

If the HyperTerminal's baud rate is not reset to 9600 bps, the system prompts "Your

baudrate should be set to 9600 bps again! Press enter key when ready".

You need not reset the HyperTerminal's baud rate and can skip the last step if you

have chosen 9600 bps. In this case, the system upgrades BootROM automatically

and prompts "Bootrom updating now.....................................done!".

Loading host software

Follow these steps to load the host software:

Step 1: Select <1> in Boot Menu and press <Enter>. The system displays the following

information:

1. Set TFTP protocol parameter

2. Set FTP protocol parameter

3. Set XMODEM protocol parameter

0. Return to boot menu

Enter your choice(0-3):

Step 2: Enter 3 in the above menu to download the host software using XMODEM.

The subsequent steps are the same as those for loading the BootROM software,

except that the system gives the prompt for host software loading instead of BootROM

III. Loading Software Using TFTP through Ethernet Port

TFTP, one protocol in TCP/IP protocol suite, is used for trivial file transfer between

client and server. It uses UDP to provide unreliable data stream transfer service.

Loading BootROM software

Figure 3-6 Local loading using TFTP

Step 1: As shown in Figure 3-6, connect the switch through an Ethernet port to the

TFTP server, and connect the switch through the Console port to the configuration PC.

Switch

Console port

TFTP client

3-8

Chapter 3 Device Management

Ethernet port

TFTP server

Table of Contents

S5510 series