H3C S3610 Series Operation Manual page 41

Hide thumbs Also See for S3610 Series:

Table of Contents

Operation Manual – System Maintenance and Debugging

H3C S3610&S5510 Series Ethernet Switches

Connected to 10.1.1.1

220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user

User(192.168.0.144:(none)): switch

331 Give me your password, please

Password:

230 Logged in successfully

[ftp] get switch.btm

227 Entering Passive Mode (10,1,1,1,4,125)

150 "D:\switch.btm" file ready to send (291284 bytes) in ASCII mode

....226 Transfer finished successfully.

FTP: 291284 byte(s) received in 4.393 second(s), 66.00K byte(s)/sec.

[ftp] bye

221 Windows FTP Server (WFTPD, by Texas Imperial Software) says goodbye.

Note:

When using different FTP server software on PC, different information will be output to

the switch.

Step 2: Update the BootROM program on the switch.

<Sysname> bootrom update file switch.btm

This command will update bootrom file, Continue? [Y/N]y

Now updating bootrom, please wait...

BootRom file updating finished!

Step 3: Restart the switch.

<Sysname> reboot

Note:

Before restarting the switch, make sure you have saved all other configurations that

you want, so as to avoid losing configuration information.

Loading the host software is the same as loading the BootROM program, except for

that the file to be downloaded is the host software file, and that you need to use the

boot boot-loader command to select the host software at reboot of the switch.

After the above operations, the BootROM and host software loading is completed.

Pay attention to the following:

3-13

Chapter 3 Device Management

Table of Contents

S5510 series