Introduction - Xylem EXO Series User Manual

|
4
pg
5. Calibration
5.1 Introduction to Basic Procedure
5.2 Calibrating Conductivity/Temperature
5.3 Calibrating Dissolved Oxygen
5.4 Calibrating Depth
5.5 Calibrating pH
5.6 Calibrating ORP
5.7 Calibrating Turbidity
5.8 Calibrating Total Algae (Chlorophyll and Blue-green Algae)
5.9 Calibrating fDOM
5.10 Calibration Standards
5.11 Calibration Record Sheet
6. Maintenance
6.1 Sonde Storage, Short-term and Long-term
6.1 Sonde Maintenance
6.2 Install/Replace Sonde Batteries
6.3 Replace Sonde Bails
6.4 Update Sonde Firmware
6.5 Handheld Maintenance and Storage
6.6 Install/Replace Handheld Batteries
6.7 Update Handheld Firmware & KOR Software on Handheld
6.8 Depth Sensor Storage and Maintenance
6.9 Standard Optical Sensors Maintenance and Storage
6.10 Conductivity/Temperature Sensor Maintenance and Storage
6.11 Dissolved Oxygen Sensor Storage, Maintenance and Rehydration
6.12 Sensor Cap Replacement
6.13 pH and ORP Sensor Storage, Maintenance and Rehydration
6.14 Sensor Module Replacement
6.15 Wiper Maintenance and Storage
6.16 Field Cable Maintenance and Storage
6.17 Antifouling Equipment Maintenance
Sacrificial Anode
6.18 Connectors Maintenance and Storage
6.19 Flow Cell Maintenance
7. Health & Safety, Warranty, Service
7.1 Chemicals
Conductivity Solutions
pH Solutions
Zobell Solution
Turbidity Standard
Ultraviolet Light (fDOM Sensor)
7.2 Radio Frequency
7.3 Declarations of Conformity
7.4 Instrument Warranty
7.5 Instrument Cleaning & Packing Instructions
7.6 Recycling