Awake Sonde, Activate Bluetooth - Xylem EXO Series User Manual

Awaken Sonde,
2.5
Activate Bluetooth
Once power is applied to the sonde, internally or externally, users can awaken their sondes from Sleep state using
any of several methods. Primarily, users activate EXO sondes and the Bluetooth connections via a magnetic
switch installed in sonde's electronics compartment. The sonde will automatically disable the connection and
go to sleep once it has not received a Bluetooth signal for 5 minutes or a signal from the topside connector
for 30 seconds. In order to activate their sondes, users should keep a magnet with them when setting up and
deploying sondes. For more information on sonde states and LEDs, please see Section 2.4.
1 Awaken sonde with magnet.
Users can make their sonde go to the Awake state by
holding a magnet at the magnetic activation area on the
sonde's bulkhead (identified by the illustrated magnet
symbol on the label). Simply hold the magnet within
one (1) cm of the symbol until the LEDs activate. EXO
Handhelds and sensor tools contain embedded magnets
identified by the same symbol.
2 Awaken sonde without magnet.
Users can also make their sonde go to the Awake state
using any of the following methods.
• Cycling power to the sonde (uninstalling/installing
batteries).
• Communicating via the topside port.
• Inserting a sensor.
In addition to these manual methods, the sonde also
automatically awakens for scheduled unattended logging
(programmed in Kor).
3 Activate sonde's Bluetooth.
Users activate Bluetooth by holding a magnet at the
magnetic activation area in the same way as described in
Step 1. In addition to magnetic activation, users can also
activate Bluetooth by:
• Cycling power to the sonde (uninstalling/installing
batteries).
• Enabling Bluetooth via a connection at the topside port
in Kor.
|
31
pg