Install Batteries - Xylem EXO Series User Manual

Install Batteries

2.1
The EXO1 Sonde uses two (2) D-cell alkaline batteries and the EXO2 Sonde uses four (4) D-cell alkaline
batteries as the recommended power source. Alternatively, the sonde may use rechargeable NiMH D-cell
batteries that you purchase. See detailed installation instructions Section 6.2
EXO1
EXO2
1. Remove battery cover.
EXO1: Twist the blue battery cover counterclockwise to
loosen, lift up to remove. Use included wrench to loosen, if
necessary.
A
Do not remove the screws on the sonde's electronics
compartment.
EXO2: Unscrew and remove battery cap. Use included
wrench to loosen, if necessary.
2. Install batteries.
Insert the batteries with positive terminals (+) facing up
and negative terminals (-) facing down toward the probes.
3. Replace battery cover.
Replace the battery cover or cap and tighten until snug. Do
not overtighten.
|
27
pg