Sun Microsystems Solaris 7 11/99 Hardware Platform Manual page 184

3. If a net alias does not exist for the network interface that is on the same subnet as
the SSP, create one by typing a command similar to the following example:
ok nvalias net /sbus@41,0/SUNW,hme@0,8c00000
Where /sbus@41,0 refers to system board 0 and SBus 1. The /SUNW,hme@0 portion
of the device name defines a 100BASE-T network interface installed in Slot 0. This
information is site-specific; thus, your configuration may vary.
The following table contains the SBus numbers used in the devalias file.
TABLE 10-1
system board
0
1
2
3
4
5
6
7
The watch-net-all command (no spaces) displays the functioning network
interfaces.
You are done setting up the OBP environment. You can now install the Solaris
operating environment, as described in the following section.
To Install the Solaris 7 11/99 Operating
Environment
You can use these instructions to install the Solaris operating environment without
saving any previous files.
During the installation, you will use the suninstall utility, which has its own
instructions. The following instructions are specific to the Sun Enterprise 10000. For
more information about the suninstall utility, refer to the Solaris installation
instructions in your Solaris media kit.
172 Solaris 7 11/99 Sun Hardware Platform Guide • November 1999
SBus Numbers in the devalias File
sysio 0 sysio 1
/sbus@40 /sbus@41
/sbus@44 /sbus@45
/sbus@48 /sbus@49
/sbus@4c /sbus@4d
/sbus@50 /sbus@51
/sbus@54 /sbus@55
/sbus@58 /sbus@59
/sbus@5c /sbus@5d
system board sysio 0
8 /sbus@60
9 /sbus@64
10 /sbus@68
11 /sbus@6c
12 /sbus@70
13 /sbus@74
14 /sbus@78
15 /sbus@7c
sysio 1
/sbus@61
/sbus@65
/sbus@69
/sbus@6d
/sbus@71
/sbus@75
/sbus@79
/sbus@7d