Sun Microsystems Solaris 7 11/99 Hardware Platform Manual page 136

2. Create the AP metadisks.
You must know the configuration of the host's hardware so that you know which
two ports are connected to the same disk array. The following steps use pln ports.
Your ports may vary, depending on the configuration of the host.
a. Display all of the ports and their disk device nodes.
# apinst
pln0
pln1
b. Create an uncommitted disk pathgroup.
# apdisk -c -p pln0 -a pln1
# apconfig -S -u
Where:
-c causes the pathgroup to be created
-p designates the primary path
-a designates the alternate path
You can verify the results by using apconfig(1M) as shown above.
c. Commit the database entries:
# apdb -C
You can verify the results of the above command by using apconfig -S.
124 Solaris 7 11/99 Sun Hardware Platform Guide • November 1999
/dev/dsk/c1t0d0
/dev/dsk/c1t1d0
/dev/dsk/c1t2d0
/dev/dsk/c1t3d0
/dev/dsk/c1t4d0
/dev/dsk/c1t5d0
/dev/dsk/c2t0d0
/dev/dsk/c2t1d0
/dev/dsk/c2t2d0
/dev/dsk/c2t3d0
/dev/dsk/c2t4d0
/dev/dsk/c2t5d0