Sun Microsystems Solaris 7 11/99 Hardware Platform Manual page 203

Note – You should have an alias (usually net) in OBP for the proper network
interface. Use that alias with the boot(1M) command, as shown in the example
above. Otherwise, you must type in the complete OBP device path. If you specify an
alias (or path) that does not describe the proper network interface, the boot(1M)
command will fail.
In the netcon(1M) window, boot the system from the network.
ok boot net
The boot net command starts the suninstall utility. This utility prompts you to
provide site and platform-specific information. Refer to the following table for the
platform-specific information you may need to supply. If you have questions about
the suninstall utility, please refer to the Installation Instructions for Solaris 7 11/99
(SPARC Platform Edition) in your media kit.
Platform-Specific Information for the suninstall Utility
TABLE 10-5
If you are asked to
Please enter the
hostname of the SSP for
domain_name
[default_name]
Set the network
information
Solaris Interactive
Installation
Select 64 bit
Select Software
Chapter 10 The Solaris 7 11/99 Operating Environment on the Sun Enterprise 10000 Server
Do this
Enter the hostname for your SSP. Note that the default is to
append -ssp to the domain_name.
Select the appropriate level of information you want to provide.
If you select any option other than None, the suninstall
utility displays a series of dialogs that request configuration
information. Provide that information.
Select Upgrade.
Click "Select To Include Solaris 64-bit Support" to install the
64-bit kernel. Refer to the Solaris 7 Release Notes Supplement for
instructions on how to check the operating mode, to set the
default mode, and to switch the operating mode.
Select Entire Distribution plus OEM Support.
191