Sun Microsystems Solaris 7 11/99 Hardware Platform Manual page 201

To Bring Up the Domain
1. In an SSP window, ensure that the SUNW_HOSTNAME variable is set to the proper
domain name.
ssp% domain_switch domain_name
Note – The domain_switch(1M) command must be executed from the C shell. By
default, the SSP window is a C shell.
2. Use the domain_status(1M) command to ensure that the OS version is set to the
proper value.
If you upgraded the SSP software to SSP 3.1.1 or SSP 3.2, the OS version should be
5.7. If you did not upgrade the SSP software, the OS version should be 2.7. If the OS
version is set to the proper value, proceed to Step 3. If not, perform the following
steps:
a. Remove the existing domain.
ssp% domain_remove -d domain_name
The domain_remove(1M) command prompts you to save the domain directories,
as in the following example:
domain_remove: The following subdirectories contain domain specific
information such as messages files, configuration files,
and hpost dump files.
directories if you still need this information.
domain may be created with or without this information
being saved.
/var/opt/SUNWssp/adm/xf4-b3
/var/opt/SUNWssp/etc/allxf4/xf4-b3
Keep directories (y/n)? y
Domain : xf4-b3 is removed !
Be sure to answer yes,
you answer no, you will have to supply the board numbers and the platform
name for the new domain.
Chapter 10
You may choose to keep these
, to the prompt so that the domain information is saved. If
y
The Solaris 7 11/99 Operating Environment on the Sun Enterprise 10000 Server
This
189