Sun Microsystems Solaris 7 11/99 Hardware Platform Manual page 190

2. Use the setenv command to set the default boot-disk alias to the correct device.
ok setenv boot-device bootdisk_alias
Where bootdisk_alias corresponds to the user-defined alias you established in Step 1.
The device should correspond to the device that you want to use as the boot disk,
which may be different than the device on which you just installed the Solaris
operating environment.
You are done configuring the OBP variables. You can now bring up the domain, as
described in the following section.
To Bring Up the Domain
1. In an SSP window, use the su(1M) command to switch the user to superuser.
2. Change to the Tools directory.
ssp# cd /cdrom/cdrom0/s0/Solaris_2.7/Tools
3. Remove the host domain as an install client.
ssp# ./rm_install_client domain_name
4. Remove the Solaris CD from the CD-ROM drive.
ssp# cd /
ssp# unshare /cdrom/cdrom0/s0
ssp# eject cdrom
5. Exit the superuser shell to the SSP window as user ssp.
178 Solaris 7 11/99 Sun Hardware Platform Guide • November 1999