Sun Microsystems Solaris 7 11/99 Hardware Platform Manual page 122

To Check the FCode Level of Your FC/S SBus
Card
1. Determine your FCode level:
ok setenv fcode-debug? true
ok reset
ok show-devs
You should see output similar to this:
.
.
.
/iommu@0,10000000/sbus@0,10001000/le@1,c00000
/iommu@0,10000000/sbus@0,10001000/SUNW,soc@0,0
/iommu@0,10000000/sbus@0,10001000/ledma@4,8400010
/iommu@0,10000000/sbus@0,10001000/SUNW,bpp@4,c800000
/iommu@0,10000000/sbus@0,10001000/espdma@4,8400000
/iommu@0,10000000/sbus@0,10001000/SUNW,DBRIe@2,10000/mmcodec
/iommu@0,10000000/sbus@0,10001000/SUNW,soc@0,0/SUNW,pln@a0000800,201cac11
/iommu@0,10000000/sbus@0,10001000/SUNW,soc@0,0/SUNW,pln@a0000800,201cac11/
SUNW,ssd
2. Look at the output from the show-devs command and find the lines for the FC/S
card(s) that is attached to the SPARCstorage Array that you want to boot from.
The output for an FC/S card will be the lines containing soc@x,x similar to:
/iommu@0,10000000/sbus@0,10001000/SUNW,soc@0,0
/iommu@0,10000000/sbus@0,10001000/SUNW,soc@0,0/SUNW,pln@a0000800,201cac11
/iommu@0,10000000/sbus@0,10001000/SUNW,soc@0,0/SUNW,pln@a0000800,201cac11
SUNW,ssd
110 Solaris 7 11/99 Sun Hardware Platform Guide • November 1999