Packer Maintenance - Labrie Expert 2000 Maintenance Manual

P M
ACKER AINTENANCE
The Expert(t) 2000 packing system
TM
has a heavyduty guiding system using
high-strength steel wear plates.
Because of the intensive use of the
packer (1000 to 3000 cycles per day),
Labrie recommends both:
TM
• a mandatory visual inspection of
the packer and its components,
performed daily by the operator;
• a mandatory inspection and
maintenance, carried out weekly by
maintenance personnel.
Greasing all moving parts on a daily
basis is very important, and the proper
adjustment of the limit switches is
imperative, especially on units
equipped with multi-cycle options.
Refer to "Lubrication" on page 123 for
detailed diagrams of greasing points
and lubrication schedule.
CAUTION
D
O NOT GREASE THE SIDE RAILS
A
BRASIVE MATERIAL STICKS TO THE
GREASE AND CAN CAUSE PREMATURE
WEAR OF THE ROLLERS AND
.
SIDE RAILS
Any problem found on the packing
system must be corrected immediately.
The Labrie Customer Support Center
is available for any type of technical
support.
A
PPLY
PROCEDURE
MAINTENANCE
CARRIED OUT ON THE VEHICLE
To prevent breakdowns and to
reduce maintenance expenses,
apply the following procedure:
1. Park the Expert(t) 2000
ground, in an area where small
debris can fall on the ground for
further collection.
2. Apply the parking brake.
3. Using the
S
select the right-hand side packer
control station (see Figure 54.
"Packer control selector switch").
:
Note:This switch is found only on
vehicles equipped with
/ multiple packer control
OR THE
stations.
Expert(t) 2000
Maintenance Manual
DANGER
THE LOCKOUT
AT ALL TIMES
OR INSPECTION
P C
ACKER ONTROL
switch on the console,
ELECTOR
43
TM
/
TAGOUT
WHEN
IS
.
on level
TM