Labrie Expert 2000 Maintenance Manual page 50

40 C 3
HAPTER
Maintenance
Clean-Out Trap
Figure 48. Hopper clean-out trap
17.
18.
Safety Pin
Figure 49. Swivel-style panel safety
door
Climb inside the hopper using a
small step-ladder;
Bring the swivel-style panel to a
vertical position and hold it,
using the handle at the upper left
corner of the panel (see Figure
49. "Swivel-style panel safety
devices");
Handle
Safety Pin
Holder
devices
19. Remove the safety pin from its
holder and put the pin in the hole
at the bottom left of the
swivel-style panel (see Figure
49. "Swivel-style panel in vertical
position (left-side view)"). This
pin is a mandatory safety device,
preventing from being caught at
the pinch point, when
manipulating the swivel-style
panel;
20. Lower the swivel-style panel
over the packer (see Figure 50.
"Tilted swivel-style panel");
Pinch Points
Figure 50. Tilted swivel-style panel
21. Remove all accumulated dirt
under the cylinder brackets and
side rails (see Figure 51.
"Cylinder bracket and side rails
(left-side view)") using a scraper
or pressurized water;