Labrie Expert 2000 Maintenance Manual page 55

then push the red emergency
button when the packer is
S
TOP
fully extended.
Emergency
Stop Button
Figure 58. Right-hand side control
station
Figure 59. Extended packer
7. Apply the Lockout/Tagout
procedure. Refer to "Lockout/
Tagout Procedure" on page 8.
A
PPLY
PROCEDURE TO PREVENT ANY ENGINE
Start
START
Cycle
Button
8.
9.
10.
Note:This wear pad wipes out dirt
11.
Expert(t) 2000
Maintenance Manual
DANGER
THE LOCKOUT
- .
UP
Check the follower panel hinges
and make sure there is no wear
on the panel surface;
Unbolt and remove the wear pad
bracket (Part #69584);
Inspect the nylon wear pad (see
Figure 61. "Extended packer").
each time the packer goes
back and forth. If this wear
pad is less than 1-inch thick,
replace it with a new one.
Visually inspect both hopper side
rails and packer rollers (Figure
60. "Packer roller") for premature
wear. See also "Packer Roller
Replacement" on page 70 and
"Wear Pads Replacement" on
page 57 for more details;
45
TM
/
TAGOUT