Labrie Expert 2000 Maintenance Manual page 75

located under the follower
panel.
Greasing
Hoses
Access
Cover
Figure 104. Packer cylinder pins,
access cover and greasing hoses
Note:The cylinder pins top plates
are provided with two (2)
threaded holes to use as a
puller by inserting two (2)
½-NC bolts.
22. After removing the cylinder pin,
start the engine and retract the
hydraulic cylinders;
23. Stop the hydraulic pump and the
engine;
DANGER
N
EVER CLIMB IN THE HOPPER WHILE
THE ENGINE IS RUNNING
24.
25.
Cylinder
Pin
26.
27.
28.
29.
Note:These wiper blades may
.
Expert(t) 2000
Maintenance Manual
Remove the four packer roller
assemblies from the follower
panels;
Fold the follower panels over the
packer;
Weld the follower panels to the
packer;
Attach the packer to a lifting
device (fork lifter) in order to
extract it from the hopper;
Re-install the new packer into
the hopper checking the
alignment of the packer with the
floor guides;
Install a new wiper blade on
each side of the packer (Figure
105. "Wiper blade");
require to be adjusted to fit
between the new packer and
the hopper walls.
65
TM