Table of Contents
Advertisement
17.
Connect the packer cylinders
(refer to "Packer Removal
Procedure" on page 61);
18.
Slowly retract the packer under
the rails until the end of the
packer stroke. Keep the packer
centered with the hopper,
re-install the side rails then tack
the floor guides to the hopper
floor (see Figure 110. "Floor
guide end-view");
Figure 110. Floor guide end-view
19.
Extend the packer to the middle
of the hopper; verify the
alignment with the hopper side
rails;
20.
Stitch weld the floor guides going
towards the back of the vehicle;
21.
Fully extend the packer to finish
welding under the packer;
22.
Check for proper operation.
Weld Here on
Both Sides of
the Floor Guide
FCAW
"
3-12
3
8
Maintenance Manual
Weld Here on
Both Sides of
the Floor Guide
Figure 111. Floor guide end-view
Expert(t) 2000
69
TM
FCAW
"
3-12
3
8
Hide quick links:
Advertisement
Table of Contents
