Labrie Expert 2000 Maintenance Manual page 57

Note:The packer multi-cycle
function lets you program up
to 8 cycles at a time.
To change the packer multi-cycle
settings:
1. Turn on the engine and the
hydraulic system (
2. Apply the parking brake;
3. On the console, turn the
switch on;
M -
ULTI CYCLE
4. Remove the front side panel
located behind the cab on the
left-hand side of the Expert(t)
2000 body;
TM
Front Side Panel
Figure 61. Front side panel
5. Locate the settings switch found
on the harness feeding the
module (see Figure 62. "Packer
multi-cycle module").
switch);
P
UMP
6.
Expert(t) 2000
Maintenance Manual
Green LED
Figure 62. Packer multi-cycle
module
On the bottom left of the packer
module, a green LED flashes on
and off (Figure 63. "Status
LED");
Flashing green LED
Figure 63. Status LED
Press and hold the button on the
settings switch (see Figure 64.
"Multi-cycle settings switch") for
47
TM