Table of Contents
Advertisement
52
C
3
HAPTER
Maintenance
Figure 74. Packer cylinder finger
Note:If the vehicle is equipped with
Levers
proximity switches (Figure 75.
"Proximity switches"), loosen
the proximity switch on the
bracket and move the
proximity switch over the
trigger lever to get the light
found on the proximity switch
to turn
. The gap between
O
N
the proximity switch and the
trigger lever must be adjusted
to 3/16 of an inch.
Cylinder
Finger
Figure 75. Proximity switches
10.
11.
12.
To adjust the packer retraction
limit switch, retract the packer to
1" before the fully retracted
position, using the yellow button
on the packer control station;
Push the red emergency-stop
button when the packer reaches
the right position;
Stop the engine and apply the
lockout/tagout procedure. Refer
to "Lockout/Tagout Procedure"
on page 8 for details.
Hide quick links:
Advertisement
Table of Contents
