5: Function Reference; Function Summary - Symmetricom XLi User Manual

S S S S S S S S S

5: Function Reference

Function Summary

The following summary lists all the XLi functions, identifies the user interfaces from which each one is
available, and provides a brief description of the function.
Available from: K = keypad, N = Network Port (Telnet), S = Serial Port, W = Web
Function
"F1 – Time Zone Offset", page 48
"F2 – 12/24 Hour Format", page 49
"F3 – Time & Date", page 50
"F4 – Serial Port Configuration",
page 52
"F5 – Time-Quality Setup", page 53
"F6 – Keypad Lock", page 55
"F8 - Continuous Time Once-per-
Second", page 56
"F9 - Time On Request", page 58
"F11 - Time Output Format", page 59
"F13 – Time Error", page 61
"F18 – Software Version Request",
page 62
"F27 – FTM III Configuration", page 63
"F42 – Multicode Output Configuration",
page 69
"F44 – N.8 Frequency Synthesizer",
page 73
"F50 – GPS Receiver LLA/XYZ
Position", page 75
"F51 – GPS Antenna Cable Delay",
page 77
"F52 – Distribution Cable Delay",
page 78
XLi Time & Frequency System
XLi-man, Issue 8, 6/17/2008, Rev. H
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
S S S S S S S S S
Available
From
K,N,S,W Set the time offset for Standard and Local time
K,N,S,W Apply a 12 or 24-hour format to the Front Panel Display, to
K,N,S,W Set the time and date (when not already provided by a
K,N,W
K,N,S,W Set the thresholds for each of the four time quality flags
K*,N,S
N,S
N,S
N,S
K,N,S,W View the current estimated worst case time error
K,N,S,W View the XLi's software version information
K,N,S,W Manage the Frequency and Time Deviation Monitor card
K,N,S,W Set the time code type and time reference for specific ports
K,N,S,W Set the frequencies generated by specific ports on the
K,N,S,W View the Latitude/Longitude/Altitude or geocentric X/Y/Z
K,N,S,W Compensate for the delay caused by the length of the GPS
K,N,S,W Compensate for the length of the distribution cable on J2.
S S S S S S S S S
Description
F8, F9, and F90.
reference source)
Configure the main serial port settings
Lock keypad access to the XLi's functions. (When locked,
F6 is the only function available from the keypad.)
Output the time once-per-second (to the command line)
Output the time when triggered (to the command line)
Change the format of the time output by F8 and F9
on the optional Multicode Output card(s)
optional N.8 Frequency Synthesizer card(s)
coordinates of one or more GPS antennas.
antenna cable. (Use F52 to adjust timing outputs.)
S S S S S S S S S
2
1
5
S S S S
45