Table of Contents
Advertisement
3
Programming
Programming can be done from any telephone or extension on
the PBX, using keypad DTMF tones. The following
programming functions are discussed in this section:
Day/Night Mode Selection
Entering Programming Mode
Resetting the PanCam/Pantel/Pancode
3.1
Day/Night Mode Selection
Day and Night mode specify which of the programmed
destination numbers, Day or Night number, will be called
when the
Call button is pressed. The operator can manually
change the Day/Night mode.
To Change the Day/Night Mode
1.
Dial the PanCam/Pantel/Pancode line/extension
from any touch-tone telephone.
2.
Wait until the PanCam/Pantel/Pancode answers and
beeps.
3.
Enter *80 for Day Mode
-or-
enter *81 for Night Mode.
3.2
Entering Programming Mode
Note: You will hear a confirmation tone every time you enter
To Enter Programming Mode
1.
Dial the PanCam/Pantel/Pancode line/extension from
any touch-tone telephone.
2.
Wait until the PanCam/Pantel/Pancode answers and
beeps.
3.
Dial *900.
4.
Enter the Programming Access Password (default
password is 1234).
To Exit Programming Mode
Dial *900
–or–
if no dialing occurs within 45 seconds, the program
mode automatically exits.
12 PanCam/Pantel/Pancode Installation and Programming Manual
a programming command.
Programming
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PanCam-C and is the answer not in the manual?
Questions and answers
תכנות קוד חדש
To program a new code for the ITS Telecom PanCam-C:
1. Dial the PanCam-C line/extension from any touch-tone telephone.
2. Wait until the PanCam-C answers and beeps.
3. Enter *900 to enter programming mode.
4. Enter the programming access password (default is 1234).
5. Enter *442 followed by the new access code (up to 4 numeric digits).
6. If the code is less than 4 digits, press # after the digits.
Notes:
- Only digits 0–9 are allowed.
- Do not use * or # in the code.
- The code cannot begin with the same digits as PBX extension numbers.
This answer is automatically generated