Table of Contents
Advertisement
OPERATION
*For Pantel
Indoor ONLY:
Busy off/on time
cadence setups for
disconnecting the
line when the
destination is busy
Digit(s) to open
the door from any
extension
Time between
DTMF's
Maximum time
for the line to be
opened (sec)
Door opening
time limit (sec)
Change the
system
administrator's
password
*For PanCam-T
Camera
instructions
PanCam-C/Pancode Setup
The PanCam-C/Pancode can work in two modes of operation:
Standard and Speed-dial.
In Standard mode, which is the default, the keypad requires
direct dialing of extensions and numbers.
In Speed-Dial mode, keys 1-9 can be assigned destination
phone numbers. When a key is pressed, the assigned
destination number is dialed.
14 PanCam/Pantel/Pancode Installation and Programming Manual
COMMAND
*371 + X + YYYY
where:
X = 1; off time setup
X = 2; on time setup
YYYY = Cadence in
step of 20 milliseconds
*441 +XXXX + #
where:
XXXX = Digits (0-9)
Note: Up to 4 digits
*460 + X
where:
X = 1-9
(each step is 200 msec)
*462 + XX
XX = Seconds (10-99)
00 = Unlimited
*464 + X
X = Seconds (1-9)
*600 + New password
(must be 4 digits).
Warning: Do not use *
or # keys
*620 + X
X = 0 camera always
off
X = 1 camera always on
X = 2 camera powered
when call button is
pressed
Programming
DEFAULT
500 msec
500 msec
8
2 (400ms)
45 sec
3 sec
1234
0
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PanCam-C and is the answer not in the manual?
Questions and answers
תכנות קוד חדש
To program a new code for the ITS Telecom PanCam-C:
1. Dial the PanCam-C line/extension from any touch-tone telephone.
2. Wait until the PanCam-C answers and beeps.
3. Enter *900 to enter programming mode.
4. Enter the programming access password (default is 1234).
5. Enter *442 followed by the new access code (up to 4 numeric digits).
6. If the code is less than 4 digits, press # after the digits.
Notes:
- Only digits 0–9 are allowed.
- Do not use * or # in the code.
- The code cannot begin with the same digits as PBX extension numbers.
This answer is automatically generated