Table of Contents
Advertisement
OPERATION
Delete a
destination
number assigned
to Day, Night, or
Error DNs. This
command must be
entered separately
for each X value
For Pancode
Indoor only
Defining the
digit(s) to open
the door from any
extension
Changing the
Opening door
Access Code
Time between
DTMF's
Conversation time
limit (sec)
Door opening
time limit (sec)
PanCam/Pantel/Pancode Installation and Programming Manual
COMMAND
*360 + X + #
where:
X = 1 Day
X = 2 Night
X = 3 Error
*371
*441 + XXXX + #
XXXX= Digits (0-9)
Note: Up to 4 digits
*442 + 0XXX+#
0XXX = New Access
Code up to four digits.
The first digit of the
access code in Speed-
dial mode must be 0.
If the new access code
is less than four
numeric digits, press the
# key following entry of
the digits. The
allowable characters are
0 through 9. Do not use
the * or # keys.
*460 + X
where:
X = 1-9
(each step is 200 msec)
*462 + XX
XX = Seconds (10-99)
00 = Unlimited
*464 + X
XX = Number of
seconds (1-9)
DEFAULT
8
0123
400
45 sec
3 sec
19
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PanCam-C and is the answer not in the manual?
Questions and answers
תכנות קוד חדש
To program a new code for the ITS Telecom PanCam-C:
1. Dial the PanCam-C line/extension from any touch-tone telephone.
2. Wait until the PanCam-C answers and beeps.
3. Enter *900 to enter programming mode.
4. Enter the programming access password (default is 1234).
5. Enter *442 followed by the new access code (up to 4 numeric digits).
6. If the code is less than 4 digits, press # after the digits.
Notes:
- Only digits 0–9 are allowed.
- Do not use * or # in the code.
- The code cannot begin with the same digits as PBX extension numbers.
This answer is automatically generated