Programming; Day/Night Mode Selection; Entering Programming Mode - ITS Telecom PanCam-C Installation And Programming Manual

3

Programming

Programming can be done from any telephone or extension on
the PBX, using keypad DTMF tones. The following
programming functions are discussed in this section:
•

Day/Night Mode Selection

•

Entering Programming Mode

•
Resetting the PanCam/Pantel/Pancode
3.1 Day/Night Mode Selection
Day and Night mode specify which of the programmed
destination numbers, Day or Night number, will be called
when the Call button is pressed. The operator can manually
change the Day/Night mode.
To Change the Day/Night Mode
1. Dial the PanCam/Pantel/Pancode line/extension
from any touch-tone telephone.
2. Wait until the PanCam/Pantel/Pancode answers and
beeps.
3. Enter *80 for Day Mode
-or-
enter *81 for Night Mode.
3.2 Entering Programming Mode
Note: You will hear a confirmation tone every time you enter
a programming command.
To Enter Programming Mode
1. Dial the PanCam/Pantel/Pancode line/extension from
any touch-tone telephone.
2. Wait until the PanCam/Pantel/Pancode answers and
beeps.
3. Dial *900.
4. Enter the Programming Access Password (default
password is 1234).
To Exit Programming Mode
•
Dial *900
–or–
if no dialing occurs within 45 seconds, the program
mode automatically exits.
PanCam/Pantel/Pancode Installation and Programming Manual 15