Selecting The Mode Of Operation; Standard Setup - ITS Telecom PanCam-C Installation And Programming Manual

3.4.1

Selecting the Mode of Operation

To Set the PanCam-C/Pancode Operation Mode
1. Dial the PanCam-C/Pancode line/extension from any
touch-tone telephone.
2. Wait until the PanCam-C/Pancode answers and
beeps.
3. Dial *900.
4. Enter the Programming Access Password (default
password is 1234.)
5. For Standard Mode, dial *151 (See 3.5.2 for
programming)
-or-
for Speed-Dial Mode, dial *152 (See 3.5.3 for
programming).
Note: After selecting the mode of operation by using *151 or
3.4.2

Standard Setup

The following table contains programming functions, which
can be accessed in the programming mode for Standard Setup
operation.
OPERATION
The Day/Night
DN will be
dialed when the
Call button
is pressed,
respective to
Day/Night
mode. The
Error DN is
dialed after
receiving three
invalid Access
Code entries in
a row
PanCam/Pantel/Pancode Installation and Programming Manual
*152, the unit will reset to default values for
each mode.
PBX Parameter Commands
*360 + X + DN + #
where:
X = 1 Day
X = 2 Night
X = 3 Error
Destination number (DN) =
Up to 20 digits, including
*,#, Pause, and A-D
characters. For special
character input, see section
3.6 Entering Special
Characters DTMF, on page
21.
COMMAND DEFAULT
Day = 0
Night = 0
Error =
No
default
15