Resetting The Pancam/Pantel/Pancode; Pancam-T/Pantel Setup And Operation - ITS Telecom PanCam-C Installation And Programming Manual

3.3

Resetting the PanCam/Pantel/Pancode

Resetting the PanCam/Pantel/Pancode will automatically
change the parameters in the unit to the manufacturers default.
To Reset the Unit
1. Enter programming mode (see section 3.2, Entering
Programming Mode).
2. Dial *151.
3. A confirmation tone will be heard.
4. Exit programming mode.
To Reset the Unit in "speed dial" mode (only
PanCam-C and Pancode)
1. Enter programming mode (see section 3.2,
Entering Programming Mode).
2. Dial *152.
3. A confirmation tone will be heard.
4. Exit programming mode.
3.4

PanCam-T/Pantel Setup and Operation

The following table contains programming functions, which
can be accessed in the programming mode for Setup and
operation.
OPERATION
Day, Night
destination
numbers
Delete the
destination
assignments
PanCam/Pantel/Pancode Installation and Programming Manual
PBX Parameter Commands
COMMAND
*360 + X + DN + #
where:
X = 1; Day destination
X = 2; Night destination
DN = Up to 20 digits.
For special character
input, see section 3.6
Entering Special
Characters DTMF, on
page 21.
*360 + X + #
where:
X = 1; Day destination
X = 2; Night destination
DEFAULT
Day = 0
Night = 0
13