Speed-Dial Setup - ITS Telecom PanCam-C Installation And Programming Manual

OPERATION
Changing the
Opening door
Access Code
Time between
DTMF's
Conversation
time limit (sec)
Door opening
time limit (sec)
Changing the
programming
password
*For
PanCam-C
Camera
instructions
3.4.3

Speed-Dial Setup

The following table contains programming functions, which
can be accessed in the programming mode for Speed-Dial
mode operation.
PanCam/Pantel/Pancode Installation and Programming Manual
COMMAND
*442 + (New Access Code)
Access Codes can be up to
four numeric digits. If the
New Access Code is less
than four numeric digits,
press the # following the
entry of the digits.
Allowable characters are 0
through 9. Do not use the *
or # keys.
Note: The access code
cannot begin with the same
prefix digits as PBX
extension numbers
*460 + X
where:
X = 1-9
(each step is 200 msec)
*462 + XX
where:
XX = Seconds (10-99)
00 = Unlimited
*464 + X
where:
X=Number of seconds(1-9)
*600 + (new password)
Programming access
password must be four
numeric digits. Allowable
characters are 0 through 9.
Do not use the * or # keys.
*620 + X
X = 0 camera always off
X = 1 camera always on
X = 2 camera powered
when call button is pressed
DEFAULT
9876
2 (400)
45 sec
3 sec
1234
0
17