Table of Contents
Advertisement
OPERATION
Delete a
destination
number
assigned to
Day, Night, or
Error DNs.
This command
must be entered
separately for
each X value
Programming
the prefix-
digit(s) for
PBX
extensions
dialing. When
input to the
PanCam-C/
Pancode begins
with these
digits, the
PanCam-C/
Pancode will
process them as
extension
dialing
Pancode Indoor
only
Digit(s) to open
the door from
any extension
16 PanCam/Pantel/Pancode Installation and Programming Manual
COMMAND
*360 + X + #
where:
X = 1 Day
X = 2 Night
X = 3 Error
*170 + prefix-digit(s) + #
Maximum 4 digits
(Do Not use * or # as prefix
digit)
To cancel this operation,
enter:
*170 + #
*371
*441 +XXXX + #
where:
XXXX= Digits (0-9)
Note: Up to 4 digits.
Programming
DEFAULT
No
default
8
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PanCam-C and is the answer not in the manual?
Questions and answers
תכנות קוד חדש
To program a new code for the ITS Telecom PanCam-C:
1. Dial the PanCam-C line/extension from any touch-tone telephone.
2. Wait until the PanCam-C answers and beeps.
3. Enter *900 to enter programming mode.
4. Enter the programming access password (default is 1234).
5. Enter *442 followed by the new access code (up to 4 numeric digits).
6. If the code is less than 4 digits, press # after the digits.
Notes:
- Only digits 0–9 are allowed.
- Do not use * or # in the code.
- The code cannot begin with the same digits as PBX extension numbers.
This answer is automatically generated