Table of Contents
Advertisement
Pin 3: Red
4.2.2 Color
Model no.
TV System
Image Sensor
CCD Total Pixels
Scanning System
SYNC System
Minimum Illumination
Resolution
S/N Ratio
White Balance
White Balance Range
Auto Iris
Electronic Shutter
Video Output
Gamma Correction
Mirror Function
Digital Zoom (2X)
Gain Control
Power Supply
Lens & View Angle
Operating Temperature
Operating Humidity
PanCam/Pantel/Pancode Installation and Programming Manual
DC 12V
MTV-54K0PI
PAL
¼-inch CCD Image Sensor
542(H) x 586(V)
625 lines, 50 fields/sec
Internal
0.5 Lux F1.2 5600°K
380 TVL/470 TVL
(Enhanced)
52dB (MIN)/60dB(TYP)
(AGC OFF)
ATW/AWB/FIX (Zero color
rolling)
AWB, ATW(3200---10000°K)
/FIX(3299°K)/
A.E.S.
1/50-1/120000 sec.
1.0Vp-p composite video
signal at 75 ohm
0.45
Optional
Optional
AGC
12V DC 85mA
45° > 0.7 mm
-20°C to 50°C
Within 85% RH
23
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PanCam-C and is the answer not in the manual?
Questions and answers
תכנות קוד חדש
To program a new code for the ITS Telecom PanCam-C:
1. Dial the PanCam-C line/extension from any touch-tone telephone.
2. Wait until the PanCam-C answers and beeps.
3. Enter *900 to enter programming mode.
4. Enter the programming access password (default is 1234).
5. Enter *442 followed by the new access code (up to 4 numeric digits).
6. If the code is less than 4 digits, press # after the digits.
Notes:
- Only digits 0–9 are allowed.
- Do not use * or # in the code.
- The code cannot begin with the same digits as PBX extension numbers.
This answer is automatically generated