Test Menu; Code Scanning Test - Denso BHT-1400QWB-CE Software User Manual

6.11. Test Menu

6.11.1. Code Scanning Test

Tap the 1: SCANNER button in the Test menu to perform a code scanning test. The screen shown below is
displayed. Then scan an actual code with the BHT, and confirm that the scanned data matches with the data
shown on the screen.
When a code is scanned, the LED indicator illuminates in blue, and the beeper sounds once.
The scanned code type, number of digits and scanned data are displayed in the screen.
The code type and number of digits are displayed in the order shown below.
Code Mark TYPE1 ( Code Mark TYPE2 ) number of digits
The scanned codes are displayed as characters.
The characters displayed on the screen vary depending on the code types as shown in the Code mark list.
The Test menu is used to perform the following hardware tests for the
BHT. To open the Test menu, tap "4:Test" in the System Menu.
1:SCANNER:
2: BEEPER:
3: AGING:
4: COM:
5: DISPLAY:
6: KEY VIBRATION: Performs a key entry and vibrator test.
− Note − Contact your sales dealer if an error occurs during the above
tests.
Code Mark (TYPE1)
Code Mark (TYPE2)
Number of digits
Scanned data
BHT-1400B
- 134 -
Performs a barcode scanning test.
Performs a beeper scale test.
Performs an aging test.
Performs a communication test.
Performs an LCD and indicator LED test.
Code Mark (TYPE1)
Code Mark (TYPE2)
Number of digits
Scanned data
BHT-1400Q
Read Parameter button:
Opens the scanner
reading parameter
menu. (refer to ".6.10
Scanner Reading
Parameters".)