IDTECK LX505 User Manual page 39

Proximity / pin access controller

Hide thumbs Also See for LX505:

Table of Contents

stands for a password that is required for verification in the RF + Password operating

mode.

refers to the Time Schedule code ('00' - '10') for the Reader#1 (i.e. the built-in reader).

If you assign a Time Schedule in this field, the new cardholder can gain access only du

ring the assigned Time Intervals. To set the Time Intervals for each Time Schedule cod

e, refer to the instructions on the Time Schedule Setup in the [F4 SETUP MENU]. If yo

u wish to give the cardholder unlimited access time, enter the default Time Schedule

code '00' for the value.

refers to the Time Schedule code ('00' - '10') for the Reader#2 (i.e. the exit reader). If

you assign a Time Schedule in this field, the new cardholder can gain access only duri

ng the assigned Time Intervals. To set the Time Intervals for each Time Schedule code,

refer to the instructions on the Time Schedule Setup in the [F4 SETUP MENU]. If you

wish to give the cardholder unlimited access time, enter the default Time Schedule co

de '00' for the value.

refers to the Reader Assignment code for the cardholder. Entering the code '0' assign

s both readers (Built-in Reader and Exit Reader) to grant access to the cardholder that

is being registered, code '1' only assigns Reader#1 (Built-in Reader) and code '2' assig

ns Reader#2 (Exit Reader). If you enter '1' in the RD field(Only Reader#1 assigned) an

d try to exit through Reader#2 (Exit Reader) then the LX505 generates an error messa

ge ("Access Door Error") on the LCD display.

refers to the ID code. Code '0' is default and codes '1' and '2' are codes are used for t

he TWO MEN MODE. Code '3' is used for the ARM/DISARM function and code '4' is a

ssigned for lost cards.

refers to the Operating Mode that the new cardholder will use on Reader#1 (i.e. the

built-in reader). If you enter '1' for MA, for example, this card holder will be able to ga

in access using his or her ID only.

'0' – Depend on System Operating Mode ([F1 SETUP MENU] > [READER#1 MODE])

'1' – ID Only Mode

'2' – ID + Password Mode

ID Registration

p.33

Table of Contents

Lx505sr