BEST ACCESS SYSTEMS W Series Service Manual page 9

S
ERVICE AND
W Series Service Manual
M
AINTENANCE FOR
Removing the core and throw member (lever shown)
Removing the keyed lever/knob (lever shown)
Removing the plain lever
Removing the access door
Loosening the escutcheon and disconnecting the connections
Removing the outside escutcheon from the door
Removing the bushings, trim hole inserts, and hub washers
Removing the field wire harness
Pulling the field wire harness through the door
Installing the wire transfer hinge
Adjusting the outside liner for the door thickness
Reinstalling the lock chassis and engaging the retractor in the latch
Reinstalling the through-bolts and RQE rose liner (IDH Max shown)
Reinstalling trim hole inserts, bushings, and hub washers
Feeding the reader wire harness connector through the wire hole
Connecting the reader wire harness to the control electronics
circuit board 5-15
Securing the through-bolt escutcheon and completing connections
Reinstalling the levers/knobs
Reinstalling the blocking plate and throw member
Reinstalling the core and throw member (lever shown)
Reinstalling the access door
Removing the core and throw member (lever shown)
Removing the keyed lever/knob (lever shown)
Removing the plain lever/knob (lever shown)
Removing the inside rose with the spanner wrench
Removing the two through-bolts
Removing the outside rose and liner assembly
Reinstalling the outside rose and liner assembly
Reinstalling the inside rose and rose liner
Reinstalling the lever/knob (keyed lever shown)
Reinstalling the core and throw member (lever shown)
Removing and reinstalling the RQE rose liner (IDH Max shown)
Removing and reinstalling the door status switch and magnet assembly
C
YLINDRICAL
5-3
5-4
5-4
5-7
5-8
5-9
5-17
5-18
5-20
5-20
5-21
5-22
5-22
5-23
Figures
L
OCKS
5-3
5-5
5-5
5-6
5-10
5-11
5-12
5-13
5-14
5-16
5-17
5-18
5-19
5-21
5-24
5-24
5-27
5-28
ix